| DuraRib Wall System is a 36″ functional wall system that provides durability and cost efficiency.
Traditional looks are achieved by the clean profile that refracts light off its 1 1/8″ high ribs. The attachment of the panel is made from the exterior with color matched fasteners.
Available in 26-gauge and 15 different colors. |
|
Architectural is a 36″ functional wall system that provides aesthetics and cost efficiency. An architecturally sculptured shadow panel is achieved with 1″ deep ribs to help conceal fasteners.
The attachment of the panel is made from the exterior with color matched fasteners.
Available in 26-gauge and 15 different colors. |
|
Allied CFW panel is a concealed fastener wall system that provides performance and compatibility. Clean, contemporary looks are achieved by the 1 1/2″ deep sculptured profile, embossed texture, and interior attachment. Available in 24-gauge or 22-gauge steel and formed into a 16″ wide 3″ deep section, Allied CFW panel comes in 27 colors and resists damage and abuse. |
| Features
The girt-bearing leg design makes panel alignment and fastener engagement consistent.
DuraRib Wall fasteners are coated with an organic material that tests seven times more resistant to rust than the typical .0003 cadmium-zinc coated fasteners.
Air Infiltration: Tested per ASTM E283 with no leakage.
Water Penetration: Tested per ASTM E331 with no water penetration. |
|
Features
Finished panels will have four major corrugations 1″ high at 12″ on center, with a 2 1/4″ x 1″ deep depression between each major corrugation.
Architectural panels are roll formed at 26-gauge or 24-gauge, 50,000 PSI minimum yield steel (ASTM A653 Grade 50) with G-90 zinc coating (ASTM Galvanized Specification A924) or Aluminum-Zinc alloy coating (ASTM Specification A792).
Architectural wall panels have a unique side lap feature. The panel ribs are designed to go in rather than out and one panel edge has a 360 degree hem that fits into the leading side lap rib. Panel side laps are very hard to find because of this feature.
Factory colored Architectural panels 26-gauge or 24-gauge, 50,000 PSI minimum yield steel (ASTM A653 Grade 50) with G90 zinc coating (ASTM Galvanized Specification A924) or Aluminum-Zinc alloy coating (ASTM Specification 792).
Architectural wall panels will be one-piece construction from base to building eave with a maximum length of 32′. All end laps will be a minimun of 4″ and shall occur at a supporting member. |
| 
